Featured

Assembling a GEET reactor - Part I

183 Views
Published
This is how I assembled the so called "GEET reactor" - Part I .
----------------------------------------------------------------------------------
1" outer pipe and 1/2 inner pipe, black seamless steel, with T-Pieces at the ends (1", 3/4", 3/4"). The inner pipe goes through both T-pieces.
I have checked the inner and outer pipe magnetic signature before and wrote it on the pipes, to make sure, that I assemble it correctly.

Tube lenghts in this case:
inner tube: 340 mm
outer tube: 200 mm

----------------------------
Edit (September 2nd, 2010):
This reactor might be too short. If you start experimenting with such kind of reactor then make it longer.
Be the first to comment