Mini Wind Turbine | Vertical Axis wind Mill | DIY Project| How to make tutorial

Make wind turbione charg. This mini wind turbine is very easy to make ansd can be used to recharge your smartphone. Make this mini wind turbine for kids. Mini wind turbine design for school project.

Click like button then start making your own small wind tutbine http://goo.gl/Ul4S5f

How to make Wind turbine (Vertical Axis). Step by step Instructions to make working model of small wind turbine or Vertical axis wind turbine (VAWT)

Things needed to Make Vertical Axis Wind Turbine

4” PVC Pipe 30 cm in length
ACP Sheet 30cm in length
Dynamo 3-5 Volt
PVC or CPVC Fittings 3T’s and 4 Elbows
Pieces of PVC or CPVC Pipe
L-Clamp Steel 4
Plate washer 2” IN Dia- 2
GI Nut that suits Dynamo Pulley
Connecting Wires
3/4” Cycle Screws 30

Tools needed to Make Vertical Axis Wind Turbine

Angle Grinder
Drilling machine
6mm drill bit
Welding machine (optional)
Spanner set
Other necessary equipment

How to Make Vertical Axis Wind Turbine (VAWT)

Step 1

Take PVC Pipe having 4inch diameter and 30 cm length.
Axially divide it into 4 equal parts using an angle grinder
Carefully use angle grinder
Make holes on one side of the PVC using 6mm drill bit
PVC 4'' 30cm
PVC 4” 30cm
PVC Pieces
PVC Pieces
Sep 2

Cut 4 pieces of ACP Sheet having 30 cm in length and 6 cm in width
Mark holes on ACP from PVC Pieces and make holes Using 6mm drill bit.
ACP Pieces
ACP Pieces

Step 3

Buy 4 steel L-clamps and cut it into required length (12 cm * 6 cm) using an angle grinder.
Take care and wear glasses while using an angle grinder.
L clamp
L clamp

Step 4

Take GI Plate washer 2” in diameter
Take a GI nut that suits dynamo pulley
Weld GI Nut at the center of the plate washer
Then weld all 4 L-Clamps on the plate washer
Propeller frame is ready.
Plate Washer
Plate Washer
Plate washer and Nut
Plate washer and Nut
Propeller Frame
Propeller Frame

Step 5

Connect ACP Sheets and PVC pieces together using cycle screws.
Use a spanner to tighten it.
Then connect these propeller blades on propeller frame.
Wind turbine propeller is ready.
Propeller Frame
Propeller Frame
propeller propeller2
Step 6

Buy PVC or CPVC fittings (4 elbows, 3 T’s).
Join these components together to make wind turbine base.
Connect the wire to the dynamo and fix it on wind turbine base.
CPVC Fittings
CPVC Fittings
Wind Turbine Base
Wind Turbine Base
Step 7

Place propeller on the wind turbine base.
Vertical axis wind turbine is ready.
Place the wind turbine in front of a Fan.
Yeah. It’s working fine
Check the output voltage using a multimeter.
Be the first to comment