Featured

Stanley Meyer's 9XA Waveform

241 Views
Published
Stanley Meyer's 9XA Waveform !!!!

CORE MATERIAL - Core from Standard 50 Hz transformer (with ferrite core from Flyback transformer not working !!!!!)

Primary coil - 300 turns / 1 mm. copper wire
Secondary coil - 300 turns / 1 mm. copper wire
(Primary and Secondary coils are wind bifilar (together with two wires) on one spool for best transfer !!!!!)
In this case - without Resonant chokes C1 and C2 !!!!
!!! If the Primary coil terminals are "reversed", Step Charge not occur !!!

Using voltage to Primary coil: 24 Volts / 0.3 Amps (After 4 diode bridge Graetz, has a filtering capacitor 10000 uF). (Note that at terminals of the primary winding is not connected diode).
Output Voltage to the Cell: +24 Vpp / 0.3 Amps

High frequency - 1 kHz
Gated frequency - 50 Hz

To Primary coil Stan Meyer not use 12 Vots!
Meyer use 120 Volts !!!! See Figure 1-14 from Memo WFC 420:
http://prikachi.com/images/701/6191701A.jpg

http://www.globalkast.com/photos.htm
http://rwgresearch.com/open-projects/stanley-meyers-wfc-tec/
http://stanleymeyermedia.com/new/index.php?do=page&id=1426225&sort=norm
Be the first to comment